Skip to Content
Help Center
Smoke and Heat SensorMy Smoke and Heat Sensor is reporting a tamper status

Smoke and Heat Sensor

Here, you'll find support for your Smoke and Heat Sensor.

My Smoke and Heat Sensor is reporting a tamper status

Try this solution

Attach the sensor to its base

A Tamper status means there is a physical disconnect on the inside of the sensor. This is usually caused by the casing of the Smoke and Heat Sensor not being fully secure.

If the Smoke and Heat Sensor is not attached to it's base, line up the body and base and give it a clockwise twist to close the sensor and the Tamper message will clear afterwards.

Need more help?

Ask a different questionSmoke and Heat Sensor
Select a different product
On this page
© Frontpoint SupportSitemap
FacebookTwitterInstagram