How Do I Add An Automation Device To My System?

Outdoor Smart Plug

1. Tap to open the navigation menu.
2. Tap Add Device.
3. Tap Other Z-Wave at the bottom of the device list. 
4. Follow the instructions on screen to trigger and add your device to your system.
   • To trigger the Outdoor Smart Plug, make sure it is plugged in and then click the button on the top of the device when prompted. 

To access the digital version of the Outdoor Smart Plug user guide, click here.

Wireless Light Control

OR

1. Tap to open the navigation menu.
2. Tap Add Device.
3. Tap Lighting and Appliance Control and select Smart Plug-In Switch.
4. Follow the instructions on screen to trigger and add your device.
   • To trigger the Wireless Light Control, make sure it is plugged in and then click the button on the top or front of the device, depending on your model when prompted.

To access the digital version of the Wireless Light Control user guide, click here.

Smart Door Lock (Yale)

1. Tap to open the navigation menu.
2. Tap Add Device.
3. Tap Lock and select Touchscreen Deadbolt.
4. Follow the instructions on screen to trigger and add your device.
   • To trigger the Smart Door Lock (Yale), remove the faceplate and use a thin tool to press the pairing button (shown below) on the side of the lock until it beeps twice.
     

To access the digital version of the Smart Door Lock (Yale) user guide, click here.

Smart Door Lock (Schlage)

1. Tap to open the navigation menu.
2. Tap Add Device.
3. Tap Lock and select Other Z-Wave Lock.
4. Follow the instructions on screen to trigger and add your device.
   • To trigger the Smart Door Lock (Schlage), follow the steps below:
     1. Press Schlage.
     2. Enter the 6 digit programming code (the programming code can be found on the back of the interior section of the lock, shown in the image below).
        
   • Press the 0 key on the lock's keypad.
   • If successful, the check mark under the 7 key on the keypad will light up. 

To access the digital version of Smart Door Lock (Schlage) user guide, click here.

Smart Light Bulb

1. Tap to open the navigation menu.
2. Tap Add Device.
3. Tap Lighting and Appliance Control and select Other Z-Wave Light.
4. Follow the instructions on screen to trigger and add your device.
   • To trigger the Smart Light Bulb, make sure it is installed in a device that has power and then turn the bulb ON. If the it is not being recognized, turn the bulb OFF then ON again. 

To access the digital version of the Smart Light Bulb user guide, click here.

Smart Thermostat

1. Tap to open the navigation menu.
2. Tap Add Device.
3. Tap Thermostat and select T-3000 Smart Thermostat.
4. Follow the instructions on screen to trigger and add your device.
   • To trigger the Smart Thermostat, make sure it is powered-on and then follow the steps below:
     1. Press the Menu button.
     2. Select Settings.
     3. Select Network.
     4. Select Add. 

To access the digital version of the Smart Thermostat user guide, click here.

Garage Door Controller

1. Tap to open the navigation menu.
2. Tap Add Device.
3. Tap Other Z-Wave at the bottom of the device list. 
4. Follow the instructions on screen to trigger and add your device to your system.
   • To trigger the Garage Door Controller, make sure it is powered-on and then click the button on the side of the device. 

To access the digital version of the Garage Door Controller user guide, click here.