Can I drill my Motion Sensor into the wall?

Yes. Our Motion Sensors have designated screw hole markings on the back plate for customers who wish to screw-mount to a wall instead of using the provided adhesive.  Follow these steps to get to these markings:

  • Open the Motion Sensor by pressing in on the rectangular tab outlined in red below.  This will remove the front cover of the Motion Sensor.

mceclip2.png

  • Remove the circuit board by pulling back on the tab indicated by the red outline below

mceclip1.png

  • Cut out or drill holes in the places indicated below.  Use the sections marked in green for flat wall mounting or the sections marked in red for corner mounting.

mceclip0.png

Was this article helpful?
4 out of 5 found this helpful

Comments

0 comments

Article is closed for comments.