What battery does the Garage Door Controller’s Tilt Sensor use?

The Tilt Sensor uses a single CR2032 battery that typically lasts 3-5 years.  The Garage Door Controller will indicate that the batteries need to be changed by going into a Low Battery status that will display on both the App and Website.  To change the batteries just follow these instructions:

  • To open the sensor, insert a tool in the indentation along long side and pry to remove the cover from transmitter
  • Pop the CR2032 battery out of the compartment and replace with positive end facing up.
  • Once complete, re-place the cover back on the sensor. It is important the cover goes back on the same way it came off. The way you can tell is, on the inside of the cover there is a small plastic piece that you want to align with a black button on the inside of the sensor.
Was this article helpful?
2 out of 2 found this helpful

Comments

0 comments

Article is closed for comments.