How does Arming and Disarming work with the Hub Touchscreen?

The current system status is displayed on top of the screen.  To arm or disarm, tap on the desired mode button among the three modes then tap the Send button on the confirmation box that appears.

  • You can arm the system without the Entry Delay timer by checking the No Entry Delay box before tapping Send.
  • You can turn off specific sensors on your system by checking the Bypass Specific Sensors box and tapping Continue.  Then on the next page check the box for the desired sensors and then tap Arm to finish arming the system.

When you tap to arm on the Stay or Away modes, the Touchscreen will display a countdown timer on the screen with the set Exit Delay.  When the timer expires, the system status will change accordingly.

Disarm the system by either tapping on the Disarm button or, if an Entry/Exit delay countdown is running, tap the cancel button.  This causes a number pad to appear on the screen.  Type in the 4-digit code correctly to disarm the system.

Was this article helpful?
0 out of 0 found this helpful



Article is closed for comments.