How do you learn the Wireless Light Control into the Control Panel?

Once you have plugged the Wireless Light Control into an outlet near your Control Panel, follow these instructions:

  • Put your Control Panel into it’s Z-wave learn mode:
    • From the Home screen of the Frontpoint App, tap the Menu button at the top left, then select + Add Device

mceclip8.png

    • Select Lighting and Appliance Control

mceclip0.png

    • Select Enbrighten Smart LED Bulb

mceclip0.png

    • Select Begin Installation

mceclip1.png

    • Once the system is ready, hit Next

mceclip6.png

  • Press the switch on the side of the Wireless Light Control.

mceclip2.png

  • You will then be prompted to type in a name for the light. Hit Next and you have successfully learned in your light.

mceclip7.png

  • Select either Done if that was the only device you were learning in or Add More if you have any other devices to learn in.
  • If the light didn't appear on screen after pressing the programming button, select My Device Won't Add and follow the on screen prompts to clear the device and try again.
Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.