How do I change the user codes directly on my Control Panel?

To manually change user codes from the panel, follow the steps listed below:

  • Press the Down arrow until you see System Programming on the screen and press OK
  • Enter your 4-digit master code and press OK.
  • You should see Access Codes displayed on the screen and then press OK
  • The screen will display your master code. Use the arrow keys to scroll to the code you would like to update
  • Press the OK button and the value section will begin to flash. Enter in your desired 4-digit code and press OK to save the changes
  • To return to the home screen, continuously press the Status button on the panel until the screen reverts to Disarmed

**The Simon XT panel can hold up to 1 master code and 8 additional user codes**

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.