1. Frontpoint Support
  2. Products
  3. Products
  4. Home Automation Products
  5. Wireless Light Control

Wireless Light Control - Master Guide

Follow

Functionality

This Light Controller is great for customers who are looking for a way to control the lamps or other plug-in devices in their home through remote commands or setting up schedules. It is also beneficial to expand their Z-Wave network with the additional function as repeaters.

 mceclip1.png

Specifications

Manufacturer/Model Number: Jasco ZW4104

Exterior Dimensions: 2"L x 4"W 

Power: 120VAC, 60Hz

Weight: 1/2lbs 

Control Panel Compatibility: Hub, XT, and IQ

Load Capacity for Both Outlets: 15Amps / 1800W Resistive

Maximum Load for Z-Wave Outlet: 600W Incandescent, 1/2HP Motor or 1800W Resistive. 

Operating Temperature: 32-104F

 Notes: 

  • There are two outlets on either side of the controller. Z-Wave outlet, and a standard non-Z-Wave outlet.
  • Only the Z-Wave side of the two outlets can be controlled by schedules and remote commands. The Z-Wave outlet side will have a Z-Wave logo to indicate the difference between the two. 

 

How to Enroll/Add Light Module (Inclusion Mode):

  • Ensure the panel and lock are within 5' from each other
  • Plug the Light Module into a wall socket
  • Place the panel into Learn Mode
  • Press and release the on/off button on the Light Module to Include. 

How to Remove/Delete Light Module (Exclusion Mode):

  • Ensure the panel and lock are within 5' from each other
  • Plug the Light Module into a wall socket
  • Place the panel into Learn Mode
  • Press and release the on/off button on the Light Module to Exclude.

To Reset Light Module to Factory Default Settings:

  • Unplug the Wireless Light Module from the wall outlet
  • Press and hold the On/Off button for at least 3 seconds while you plug the switch back into the wall outlet.   
Was this article helpful?
1 out of 9 found this helpful

Comments

0 comments

Article is closed for comments.

Articles in this section