Garage Door Controller - Master Guide

Functionality

 The Garage Door Controller is great for customers who want the alternative of remotely opening and closing their garage door, as well as receiving notifications if the garage door has been left open for too long. 

mceclip0.png

Specifications

Garage Controller Device Specifications: 

Manufacturer/Model Number: GoControl GD00Z-4

Exterior Dimensions: 6.94" x 1.38" x 5.0"

Power: (Input 120VAC, 0.8A) / (Output 12VDC, 2A)

Audible Alarm. 45db at 10'

Strobe Light: 360 Lumens

Mounting: Screws & anchors to ceiling or bracket. 

Operating Temperature: -4° - 122°F

 

Garage Door Tilt Sensor Specifications: 

Exterior Dimensions: 1.69" x 0.88" x 1.19"

Power: CR2032 Coin Cell Battery

Battery Life: ~2 years

Range: 100' from GD00Z-4 Controller

Mounting: Double-sided adhesives or two mounting screws

Operating Temperature: -4° - 122°F

 

Notes: 

If the customer has a MyQ Garage Opener, a Garage Door Controller is NOT required and may be paired through the FP App directly. Check both the Garage Door Control and LiftMaster Integration are enabled on the ADC Service Package. UM is required for garage door integration. Though Frontpoint does not support the LiftMaster integration, it is compatible and may be paired. See Alarm.com's Support Knowledge Base for Liftmaster Integration.

 

The Garage Door Opener is Incompatible with Single-Piece garage doors (See below):

 

Incompatible Garage Door Opener by Model: 

Chamberlain MyQ

  • WD962KEV, KPEV & MLEV
  • WD1000WF
  • WD832KEV
  • HD 930EV & 420EV
  • HD 950WF 
  • LW500EV
  • LW9000WF
  • PD752D & KPV

 Genie Series III

  • PowerMax 1500
  • TriloG 1200 & 1500
  • IntelliG 1000 & 1200
  • IntelliG CM8600
  • PRO 1024 & 2028
  • POWERLIFT 900

 LiftMaster MyQ

  • 2575, 2587, 2595
  • 3800PLD, 3585, 7356, 7675
  • 8155, 8522, 8355, 8360, 8500, 8550, 8557, 8587, 8587W, 8587WL

 Craftsman AssureLink / MyQ

  • 3043 & 30437 

Raynor

  • Ultra II

Marantec

  • Synergy 270

Overhead Garage Door

  • Odyssey 1200

 

 How to Enroll/Add Garage Controller (Inclusion Mode):

  • Ensure the Panel and Garage Controller are within 5' from each other
  • Plug the Garage Controller into a wall socket
  • Place the panel into Learn Mode
  • Press and release the Link button on the Garage Controller Device to Include. 

How to Remove/Delete Garage Controller (Exclusion Mode):

  • Ensure the Panel and Garage Controller are within 5' from each other
  • Plug the Garage Controller into a wall socket
  • Place the panel into Delete Mode
  • Press and release the Link button on the Garage Controller Device to Exclude

To Reset Garage Controller to Factory Default Settings:

  • Press the Link button 5 times. A quick beep followed by a long beep will then sound, indicating the reset was successful. 

Click here to access the User Guide for the Garage Door Controller.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.