How do I add a third party Z-Wave device to my account?

Once you have your device near your Control Panel and receiving power, follow these instructions:

  • Put your Control Panel into it’s Z-wave learn mode:
    • From the Home screen of the Frontpoint App, tap the Menu button at the top left, then select + Add Device

mceclip8.png

    • Select Other

mceclip0.png

    • Select Begin Installation

mceclip2.png

    • Once the system is ready, hit Next

mceclip6.png

  • Perform the programming command according to the instructions of your device.
  • You will then be prompted to type in a name for the device. Hit Next and you have successfully learned in your device.

mceclip7.png

  • Select either Done if that was the only device you were learning in or Add More if you have any other devices to learn in.
  • If the light didn't appear on screen after pressing the programming button, select My Device Won't Add and follow the on screen prompts to clear the device and try again.
Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.